Warning # 090

September 29, 2005, 12:31

Hi All,

I was runnning a combustor model in STAR CD 3.15 but when I am running the same model in STAR CD 3.24, I am getting following warning.

*** WARNING #090 *** VALUE ELOG*YPLUS OR ELOG*EFFVIS/(CAPPA*VISCOS) IS LESS THAN 1.1 AT 200 CELLS. UPLUS=YPLUS LAW IS USED. IF THIS SITUATION PERSISTS, INCORRECT RESULTS MAY BE OBTAINED.

The results vary by about hundred degrees, higher temperatures are obtained from 3.24.

Thanks,

November 26, 2005, 02:27

If this warning persists after 200 iterations then you have to refine the mesh near wall region(I am assuming that you are doing a steady state analysis)

DB

September 29, 2005, 12:31	Warning # 090	#1
Vishal Guest Posts: n/a	Hi All, I was runnning a combustor model in STAR CD 3.15 but when I am running the same model in STAR CD 3.24, I am getting following warning. * WARNING #090 * VALUE ELOGYPLUS OR ELOGEFFVIS/(CAPPA*VISCOS) IS LESS THAN 1.1 AT 200 CELLS. UPLUS=YPLUS LAW IS USED. IF THIS SITUATION PERSISTS, INCORRECT RESULTS MAY BE OBTAINED. The results vary by about hundred degrees, higher temperatures are obtained from 3.24. Thanks,

November 26, 2005, 02:27	Re: Warning # 090	#2
DB Guest Posts: n/a	If this warning persists after 200 iterations then you have to refine the mesh near wall region(I am assuming that you are doing a steady state analysis) DB

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Warning 046, what does it mean?	SAKTI	Siemens	1	July 31, 2008 13:14
warning #064	ema	Siemens	1	August 25, 2005 06:45
warning # 90	vishal	Siemens	1	August 11, 2005 10:19
* WARNING #052 *	Cirilo	Siemens	1	July 27, 2005 09:34
Warning	Paco	Siemens	0	June 23, 2005 03:33