Flip trim type 2 cell

August 25, 2005, 05:02

hi all, i want to know how to flip trimmed cell type 2. i tried: cflip,cset,,,right and cflip,cset,,,trim but i didn't work.

Thanks.

August 25, 2005, 05:04

cfix cset,,,hand

August 25, 2005, 10:08

I just went through this exercise and I believe Oliver is correct.

cfix,cset,,,hand will flip trim cells.

For a bad trim type 1 cell, my results showed: 1) cfix,cset,,,hand corrects the cells. 2) cfix,cset,,,fix reports that it flips the cell but check,,right reports it is still bad. 3) cfli,cset, and cfli,cset,,,trim fail to flip the cell but at lwast reported that it did nothing.

These results are for v3.24 on an Opteron.

August 25, 2005, 05:02	Flip trim type 2 cell	#1
soy Guest Posts: n/a	hi all, i want to know how to flip trimmed cell type 2. i tried: cflip,cset,,,right and cflip,cset,,,trim but i didn't work. Thanks.

August 25, 2005, 05:04	Re: Flip trim type 2 cell	#2
Oliver Guest Posts: n/a	cfix cset,,,hand

August 25, 2005, 10:08	Re: Flip trim type 2 cell	#3
Pauli Guest Posts: n/a	I just went through this exercise and I believe Oliver is correct. cfix,cset,,,hand will flip trim cells. For a bad trim type 1 cell, my results showed: 1) cfix,cset,,,hand corrects the cells. 2) cfix,cset,,,fix reports that it flips the cell but check,,right reports it is still bad. 3) cfli,cset, and cfli,cset,,,trim fail to flip the cell but at lwast reported that it did nothing. These results are for v3.24 on an Opteron.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Cell type other than Hex in tutorials	tj22	ParaView	3	May 11, 2006 17:18
Cell type litterature	Christian	Main CFD Forum	0	March 17, 2006 08:01
change of cell type	CFDuser	Siemens	1	March 10, 2006 20:04
change cell type during calculation	Torsten	Siemens	1	May 27, 2005 08:16
is it possible to change cell type during calc?	raymond	Siemens	2	September 21, 2001 03:10