|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I am getting following error messages while running my simulation. How I am going to solve this problem? Thanks.
*** WARNING #001 *** FLUID INFLOW DETECTED AT SOME OUTFLOW BOUNDARIES WHERE MASS FLUXES ARE FORCED TO ZERO. IF THIS CONDITION PERSISTS, YOUR RESULTS MIGHT BE WRONG *** WARNING #066 *** TEMPERATURE LESS THAN MIN. RANGE TEMPERATURE AT 49140 CELLS. MINIMUM TEMPERATURE OF 0.200E+03 AT CELL 1799 *** WARNING #042 *** PROCESS NOT FULLY CONVERGED -- EQ.,NIT,RESI: SC1 101 0.63688E+00 *** WARNING #043 *** MINIMUM RESIDUAL AT THE END, RETURNING NON-CONVERGED SOLUTION |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error message-Floating point error | Vaibhav | FLUENT | 3 | December 7, 2007 05:38 |
ERROR MESSAGE: line 1: parse error | Lourival | FLUENT | 1 | February 18, 2006 01:35 |
help on error message | zwdi | FLUENT | 1 | January 10, 2004 22:58 |
Error message | RM | FLUENT | 2 | January 8, 2004 06:05 |
Gambit 2.0 - Error Message (ACIS ERROR 1200) | James | FLUENT | 1 | May 14, 2003 08:13 |