ask for help::the error of moving grid

June 14, 2005, 10:53

hello,everyone. i have made a 3D model about moving mesh just like tut11. i can do the "pmovlink" and "starlink".but when it is going to analysis, a error appeared:

***error #240 *** 884 master faces and 477 slave face remain unmatched.check moving grid commands,or change area tolerance factor(RCON 12) current tolerance factor: 0.200e-01 change to at least:1.000

i have change the RCON 12 to 1,but the error remained. can anyone tell me why the error happened,and hoee to solve it. and how to setup the master and slave at the boundary???

June 16, 2005, 01:10

It may be because of attach boundary.

June 14, 2005, 10:53	ask for help::the error of moving grid	#1
shure Guest Posts: n/a	hello,everyone. i have made a 3D model about moving mesh just like tut11. i can do the "pmovlink" and "starlink".but when it is going to analysis, a error appeared: *error #240 * 884 master faces and 477 slave face remain unmatched.check moving grid commands,or change area tolerance factor(RCON 12) current tolerance factor: 0.200e-01 change to at least:1.000 i have change the RCON 12 to 1,but the error remained. can anyone tell me why the error happened,and hoee to solve it. and how to setup the master and slave at the boundary???

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
moving grid	mazaheri	FLUENT	1	July 19, 2006 13:07
moving grid	Dr C.Bhasker	Siemens	4	August 31, 2005 03:29
Grid Moving	Karthik Krishna	FLUENT	4	February 23, 2005 08:57
HELP: moving grid	Sunlight007	Siemens	0	June 5, 2003 18:11
Moving grid(BC)	faithkim	Main CFD Forum	11	September 11, 1999 15:07

June 16, 2005, 01:10	Re: ask for help::the error of moving grid	#2
som Guest Posts: n/a	It may be because of attach boundary.