Home > Forums > Software User Forums > Siemens

Too many cells in near-wall layer

Updated Threads

Reply

Search this Thread

April 24, 2005, 03:47	Too many cells in near-wall layer	#1
Ahmed Guest Posts: n/a	Hi, I am using k-epsilon low reynolds number model in a channel flow. However, I am getting following error message, " Too many cells in near-wall layer". I need help to solve this problem. Thanks.

April 25, 2005, 06:56	Re: Too many cells in near-wall layer	#2
Volker Guest Posts: n/a	Try editing your parm.inc (in all sub-directories if you run prallel). Increase the parameter MAXSC2. That might help.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Adapt mesh without modifying boundary layer cells?	Freeman	FLUENT	0	February 22, 2009 15:11
dynamic mesh + boundary layer cells	Geri	FLUENT	0	November 1, 2007 17:27
dynamic mesh bondary layer cells	geri	FLUENT	4	October 16, 2007 10:47
Add a layer of cells, UDF, dynamic mesh or ...?	Modisa	FLUENT	0	March 17, 2007 12:59
Add a layer of cells, dynamic mesh or ...?	Modisa	FLUENT	1	March 12, 2007 03:01

All times are GMT -4. The time now is 22:53.