|
[Sponsors] |
April 19, 2005, 06:48 |
thp question of moving grid
|
#1 |
Guest
Posts: n/a
|
hi ,dear all:
I run a model of moving grid.But when it begins to run the program,always disply the error message.The message is "Error#240 96 master faces and 96 slave face remain unmatched; check moving grid command or change area tolerance factor". Can any one give some advice about the problem? |
|
May 29, 2005, 06:01 |
Re: thp question of moving grid
|
#2 |
Guest
Posts: n/a
|
hello!When you run the model using ASI as tut11-1,you will get the result.I have the same problem like you,but when i have modified the cgrid.cgrd,i got the correct result.Please refer to tut13-1,understand the content of it and you will solve your problem.you can contact me by QQ:359489266.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
moving grid | mazaheri | FLUENT | 1 | July 19, 2006 13:07 |
moving grid | Dr C.Bhasker | Siemens | 4 | August 31, 2005 03:29 |
some question about moving grid and fortran | shure | Siemens | 4 | April 18, 2005 23:12 |
Moving Body Grid Question | Matt | Main CFD Forum | 5 | September 13, 2004 01:45 |
Moving grid(BC) | faithkim | Main CFD Forum | 11 | September 11, 1999 15:07 |