Hi,

I am running a transient analysis with free surface option. When I am plotting the current results (the current analysis time is at 0.3 secs), I get only the results on a very small area of the whole mesh. For instance, if I want to plot UVW velocities (or pressure), the 'colorful arrows (or contours)' appear only in some (less than 5%) area of the whole mesh and I know from logic that this is not the case. What may be the problem? Is it sth to do with my model, or there other stuff that I need to do to get the correct plot. Please advice and thanks...

Shazlan

"When I am plotting ..."

This is not helpfull. If you instead write down the commands you used, it is much easier to find out what went wrong.

ok... here you go. is this sufficient? or if there's a way i can upload the screendump, please let me know. apprecaite your help! thanks..

trload,toinew.pstt,nomvgr,,c store,iter,67 psys,1 getc, ALL ,None plty ehid, $edge,off $plme,off $lswi,off$ popt,vect $thin,1 $term,,,vect $cplo plty sect, $surf,on $edge off$ plme,off $lswi,off$ popt,vect $thin,1 $term,,,vect $repl

shazlan

if you do an "edge on" you will see, how the section is defined within the domain. Maybe it only cuts a small area of the domain.