Help: Moving Mesh with SUBROUTINE

March 21, 2005, 23:31

I use the following codes in prostar:

time trans | mvgrid on | geom,XXX | prob,XXX

then in terminal,

pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME GEOMETRY FILE TITLE

*** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1

RELINK pmov AFTER UPDATING THE PARAMETER FILE

===============================================

HOW TO make it correct? thanks

March 22, 2005, 02:09

You have to do the pmovlink only if you work with events or do the mesh movement with prostar. So how does you move the mesh? It seems that you have no events defined.

It might help you to run the mixer tutorial at first.

March 22, 2005, 04:24

I move the mesh only with NEWXYZ.f. thanks a lot.

March 22, 2005, 06:55

Then, you don't need to run pmovlink at all.

March 22, 2005, 08:52

that is to say: I use the "mvgrid on" only, then "starlink". that's ok?

March 21, 2005, 23:31	Help: Moving Mesh with SUBROUTINE	#1
Dorain Guest Posts: n/a	I use the following codes in prostar: time trans \| mvgrid on \| geom,XXX \| prob,XXX then in terminal, pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME GEOMETRY FILE TITLE * ERROR * MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE =============================================== HOW TO make it correct? thanks

March 22, 2005, 02:09	Re: Help: Moving Mesh with SUBROUTINE	#2
Jörn Beilke Guest Posts: n/a	You have to do the pmovlink only if you work with events or do the mesh movement with prostar. So how does you move the mesh? It seems that you have no events defined. It might help you to run the mixer tutorial at first.

March 22, 2005, 04:24	Re: Help: Moving Mesh with SUBROUTINE	#3
dorain Guest Posts: n/a	I move the mesh only with NEWXYZ.f. thanks a lot.

March 22, 2005, 06:55	Re: Help: Moving Mesh with SUBROUTINE	#4
John Luo Guest Posts: n/a	Then, you don't need to run pmovlink at all.

March 22, 2005, 08:52	Re: Help: Moving Mesh with SUBROUTINE	#5
dorain Guest Posts: n/a	that is to say: I use the "mvgrid on" only, then "starlink". that's ok?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving Reference frame - UDF - Moving mesh	modisa	FLUENT	0	April 18, 2008 14:31
moving mesh in cfx	Ravi	CFX	2	June 12, 2007 15:01
moving mesh	Mac	Siemens	0	December 16, 2005 03:57
Moving Mesh & Not Rotating Mesh	AB	Siemens	1	October 25, 2004 04:10
moving mesh	Javier Fernandez	FLUENT	1	August 31, 2000 20:55