Moving Mesh with NEWXYZ

March 20, 2005, 01:30

I'm using subroutine NEWXYZ.F to move mesh, but i could not set the correct moving event. how to do it?

thanks very much!

March 20, 2005, 23:49

Linking pmov executable...

FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE

*** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1

RELINK pmov AFTER UPDATING THE PARAMETER FILE

How to make it correct? thanks.

March 21, 2005, 03:45

I use the following codes in prostar:

time trans mvgrid on geom,XXX prob,XXX

then in terminal,

pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE

*** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1

RELINK pmov AFTER UPDATING THE PARAMETER FILE

HOW TO make it correct? thanks

March 20, 2005, 01:30	Moving Mesh with NEWXYZ	#1
Dorain Guest Posts: n/a	I'm using subroutine NEWXYZ.F to move mesh, but i could not set the correct moving event. how to do it? thanks very much!

March 20, 2005, 23:49	Re: Moving Mesh with NEWXYZ	#2
dorain Guest Posts: n/a	Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE * ERROR * MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE How to make it correct? thanks.

March 21, 2005, 03:45	Re: Moving Mesh with NEWXYZ	#3
dorain Guest Posts: n/a	I use the following codes in prostar: time trans mvgrid on geom,XXX prob,XXX then in terminal, pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE * ERROR * MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE HOW TO make it correct? thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving Reference frame - UDF - Moving mesh	modisa	FLUENT	0	April 18, 2008 14:31
Who has some samples about subroutine newxyz?	jshi	Siemens	3	May 9, 2006 21:29
How to get pressure value in 'NEWXYZ' subrutine	Henry Huang	Siemens	2	March 6, 2006 06:37
NEWXYZ	leo	Siemens	0	February 4, 2003 18:59
subroutine newxyz	leo	Siemens	3	October 3, 2002 07:24