|
[Sponsors] |
October 30, 2004, 08:13 |
Parm.inc error when running analysis
|
#1 |
Guest
Posts: n/a
|
Hi Guys
Wondering if you can help me. Im trying to run a 2D model at the moment, once the meshing is complete I try to set analysis options before writing .geom and.prob files then an error occurs saying no parm.inc file could be found? Does anyone know how I cen write a parm.inc file or where I can find it.. Thanks Chris |
|
October 30, 2004, 08:40 |
Re: Parm.inc error when running analysis
|
#2 |
Guest
Posts: n/a
|
Hello Chris,
I think if you go ahead and just write the *.geom file it should create the parm.inc. Also you might get errors in writting the geometry due to bad cells so I would make sure I have a perfect mesh before finalizing the problem file and setting up boundary conditions. Kevin |
|
October 30, 2004, 08:47 |
Re: Parm.inc error when running analysis
|
#3 |
Guest
Posts: n/a
|
Ok Kevin
Thanks for your help, will look at it now and try evaluate the problem regions... Chris |
|
November 1, 2004, 13:28 |
Re: Parm.inc error when running analysis
|
#4 |
Guest
Posts: n/a
|
A Param.inc error can be due to several reasons. I used to get a similar error when the license file for StarCD cud not be read!!!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
setting NCTMXD=NCMAX in parm.inc | Lokesh | Siemens | 0 | March 5, 2009 14:27 |
Floating point Error while running MRF analysis | Kashif | FLUENT | 1 | November 21, 2007 02:15 |
FIDAP RUNNING ERROR "ERROR-DIR-NOT-EMPTY=145" | BAOYU | FLUENT | 0 | January 26, 2006 19:32 |
setting NCTMXD=NCMAX in parm.inc | ROr | Siemens | 2 | November 4, 2005 10:40 |
Running new analysis | Julie Polyakh | Siemens | 1 | October 21, 2002 09:16 |