 |
 |
 |
|
|
|
[Sponsors] | ||||
July 5, 2004, 14:45
|
Balance checks
|
#1 |
|
Guest
Posts: n/a
|
Hello,
From the balance checks file I've got that: Materialwise enthalpy balance = Ein – Eout = 2.224 (W) It isn't good enough, is it? What could be the meaning of such a difference? What value is acceptable? Regards, Julie |
|
|
||
|
July 5, 2004, 14:59
|
Re: Balance checks
|
#2 |
|
Guest
Posts: n/a
|
How big are Ein and Eout? If it is in the range 1000-10000, the error 2/1000-10000 is more than negligible and you can consider your solution as converged (with respect to the enthalpy balance of course).
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to check Heat Balance in heat transfer like mass balance for flow | mahendra | OpenFOAM Post-Processing | 15 | February 8, 2012 11:19 |
| [blockMesh] BlockMesh checks | msrinath80 | OpenFOAM Meshing & Mesh Conversion | 1 | April 16, 2007 07:47 |
| Cell Quality Checks -> CPmatches | Derek | Siemens | 2 | August 6, 2004 05:36 |
| mass balance | Neser | CFX | 6 | February 14, 2004 01:29 |
| HOL // Mass balance | Mehdi BEN ELHADJ | Phoenics | 0 | September 4, 2000 15:56 |
Linear Mode
