|
[Sponsors] |
April 16, 2004, 02:49 |
couples issue
|
#1 |
Guest
Posts: n/a
|
Hi there,
I want to create couples in fluid and solid cells. The problem here is that there is some partial overlapping at some cells. So the couple check gives error messages (partial overlapping) while writing geometry file. I have checked other checks independantly and all are ok. Is it ok if I write geometry file without check? Kindly guide if anybody faced similar problem. - Thanks |
|
April 16, 2004, 02:58 |
Re: couples issue
|
#2 |
Guest
Posts: n/a
|
well, as far as i know, partial boundaries between fluids and solids are not permitted.
if you run the case (if it is possible) then have a look at flow field around these corner. i would expect some unexpected behaviour. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cell Couples in CCM+ | norbinou | Siemens | 4 | September 10, 2007 10:00 |
When we need to define Couples! | Mehdi | Siemens | 2 | March 23, 2006 23:15 |
about couples | bv | Siemens | 1 | July 24, 2005 07:05 |
Boundary Couples | ale | Siemens | 0 | January 26, 2004 05:09 |
couples or not couples... | giosue | Siemens | 5 | March 1, 2003 00:11 |