 |
 |
 |
|
|
|
[Sponsors] | ||||
October 10, 2003, 01:51
|
fine mesh ==> coarse mesh
|
#1 |
|
Guest
Posts: n/a
|
How can I turn the fine mesh into coarse mesh (i. e. I refined some cells by mistake)?
|
|
|
||
|
October 10, 2003, 13:12
|
Re: fine mesh ==> coarse mesh
|
#2 |
|
Guest
Posts: n/a
|
If you refined with the cmrefine command, and you have the appropriate casename.refi file, you can use cmunrefine.
If you used crefine, their is no "undo" option. Assuming you haven't done a save, you can resume your original model file. |
|
|
|
||
|
October 10, 2003, 15:09
|
Re: fine mesh ==> coarse mesh
|
#3 |
|
Guest
Posts: n/a
|
you also use the command crse, but make sure that you the gid you coursen can be coursened by 2x2x2
allan |
|
|
|
||
|
October 11, 2003, 02:19
|
Re: fine mesh ==> coarse mesh
|
#4 |
|
Guest
Posts: n/a
|
Thanks!!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Create fine mesh that grows to coarse mesh (Urgent | CZ | FLUENT | 1 | January 3, 2009 11:36 |
| Initial condition data file from coarse mesh case | Kushagra | FLUENT | 1 | July 25, 2008 22:53 |
| HOW turbulene Grid (avoid too fine or too coarse)? | Toulouser | FLUENT | 1 | February 1, 2007 04:47 |
| CFdesign behaviour in coarse and fine mesh | Farhad | Autodesk Simulation CFD | 0 | May 30, 2006 11:10 |
| streamfunction from u and v on a coarse mesh | ryoga | Main CFD Forum | 0 | February 1, 2002 19:20 |
Linear Mode
