 |
 |
 |
|
|
|
[Sponsors] | ||||
September 21, 2003, 04:07
|
Erosion problem
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
Is there anyone who has the experience in simulating erosion problem by using STAR_CD? I have done all the jobs, including calculating the two-phase flow and use the subroutines for erosion model as well as rebound model to calculated the erosion. But when I finished all of the procedures, all the data of erosion rate, erosion ratio, impact velocity and impact angle are zeros. Can anyone tell me what happened? Ko |
|
|
||
|
September 24, 2003, 06:47
|
Re: Erosion problem
|
#2 |
|
Guest
Posts: n/a
|
In the 15th issue of Star-CD newsletter there was a small article on errosion modelling. It was done by Wood Group Pressure Control Ltd, you can try to contact them.
|
|
|
|
||
|
September 24, 2003, 08:48
|
Re: Erosion problem
|
#3 |
|
Guest
Posts: n/a
|
Sometimes, this indicates that you have some problems with the particule trajectory calculation. Do you check that all particules exit the fluid domain.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EROSION UDF | shehab abdelrahman | FLUENT | 1 | February 12, 2008 06:15 |
| Pipe bend erosion problem | John Yang | FLUENT | 2 | December 12, 2007 05:06 |
| about erosion problem caused by solid particles | hannah | CFX | 4 | August 20, 2003 05:42 |
| Erosion | David Connolly | Phoenics | 1 | June 24, 2002 07:16 |
Linear Mode
