|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Catia CATScript doesn't create a geometry!!!!???
I use Catia V5 to create my geometry. I maked a macro.CATScript in which I would like to change the parameters of some surface. At the end the macro makes a Update and then saves the geometry to STL file. So i think that all the things goes right but when I verified I found that the Geometry was the same of that of the beginning (unchanged geometry). Anyone can tell me why??? bye thanks |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
I'm not sure about problem Whenever I had experienced the error, I used "cln" commands to origin cad file to check geometry
----^^; |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Airfoil 2D Geometry Parametrization | Vikram Singh | Main CFD Forum | 0 | July 31, 2008 02:20 |
CATIA - Parametrization | stex | Main CFD Forum | 0 | May 27, 2003 03:49 |
Catia - Parametrization | stex | CFX | 0 | May 27, 2003 03:47 |
Parametrization | Stex | CFX | 10 | January 21, 2003 06:59 |
parametrization | Stex | CFX | 6 | January 17, 2003 07:51 |