Multi Phase option problem....

May 21, 2003, 13:52

Hi StarCD experts! I'm trying to run an analysis using the multi phase treatment on "Lagrangian Multi-phase". I have already solved my geometry (which is on Transient) and now I'm trying to put some Droplets.. When I restarting the analysis and I'm receiving a very "wierd" message:

" *** GEOMETRICAL CALCULATIONS STARTED *** GEOMETRICAL CALCULATIONS COMPLETED

*** ERROR #244 *** MULTI-PHASE OPTION CHOSEN: INADEQUATE PARAMETER NCMAXV or/and NCTMXC IN parm.inc "

I have already tried to correct the value in the prosize file with no luck... Can anyone suggest something?

May 22, 2003, 08:53

Could be a prostar bug or could be caused by your not writing geometry file after turning on droplet. The solution is very simple: just edit parm.inc and put NCMAXV = NCMAX, NBMAXV=NBMAX, NBTMXC=NBMAX, NCTMAXC=NCTMAX and use starlink again.

May 21, 2003, 13:52	Multi Phase option problem....	#1
Christos Sfyris Guest Posts: n/a	Hi StarCD experts! I'm trying to run an analysis using the multi phase treatment on "Lagrangian Multi-phase". I have already solved my geometry (which is on Transient) and now I'm trying to put some Droplets.. When I restarting the analysis and I'm receiving a very "wierd" message: " * GEOMETRICAL CALCULATIONS STARTED * GEOMETRICAL CALCULATIONS COMPLETED * ERROR #244 * MULTI-PHASE OPTION CHOSEN: INADEQUATE PARAMETER NCMAXV or/and NCTMXC IN parm.inc " I have already tried to correct the value in the prosize file with no luck... Can anyone suggest something?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem about multi-phase analysis (Urgent)	Prof. Lau (PolyU)	CFX	2	February 9, 2007 18:59
A strange problem when doing multi-phase flow	Yun Kang	CFX	0	September 28, 2006 10:26
Phase change with granular option.	MP	FLUENT	0	February 2, 2003 22:15
heat transfer problem in multi-phase flow	verypuzzled	CFX	1	October 3, 2001 12:16
Multi-phase	cehuang	FLUENT	2	October 1, 2001 16:25

May 22, 2003, 08:53	Re: Multi Phase option problem....	#2
John Guest Posts: n/a	Could be a prostar bug or could be caused by your not writing geometry file after turning on droplet. The solution is very simple: just edit parm.inc and put NCMAXV = NCMAX, NBMAXV=NBMAX, NBTMXC=NBMAX, NCTMAXC=NCTMAX and use starlink again.