 |
 |
 |
|
|
|
[Sponsors] | ||||
December 13, 2002, 05:03
|
how to post process with visual3
|
#1 |
|
Guest
Posts: n/a
|
how to export the starcd result for visual3(icemcfd4.2.2).i used the command "icem write",but it export nothing
|
|
|
||
|
December 13, 2002, 11:48
|
Re: how to post process with visual3
|
#2 |
|
Guest
Posts: n/a
|
Try exporting as Tecplot format. Then open in V3 as Tecplot format. Only ProSTAR/AM v3.103.520 can output properly to ICEM-CFD and you can only get it by special request.
|
|
|
|
||
|
December 17, 2002, 02:59
|
Re: how to post process with visual3
|
#3 |
|
Guest
Posts: n/a
|
could u plz tell me the system varilbes need to activate the visual3p??
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem of post-process pressure. | Bernie | FLUENT | 1 | December 2, 2012 06:44 |
| post process to get an arbitrary face data | oniboy | Siemens | 2 | February 28, 2008 23:12 |
| Need a post-process software | Munikrishna | Main CFD Forum | 3 | November 27, 2006 14:45 |
| severe error in cfx-post process | chang | CFX | 0 | May 18, 2006 12:43 |
| 200 data files to post process (how?) | Mark R | FLUENT | 1 | August 9, 2001 14:35 |
Linear Mode
