Adding cells during mesh motion

December 4, 2002, 02:31

I try to simulate a flow in a cylinder gap of 0.2 mm with a piston jump stroke of up to 30 mm.

Has anybody experiences in succeeding in this kind of example with Star-CD, especially by adding/removing cells during mesh motion?

Thanks & regards

December 23, 2002, 04:22

I had simulated a flow in a cylinder gap of 0mm with a piston jump stroke of up to 2mm,but without using adding/removing cells during mesh motion.What difficults did you face in doing it?Perhapes I can help you.

December 4, 2002, 02:31	Adding cells during mesh motion	#1
Serkan Cetin Guest Posts: n/a	I try to simulate a flow in a cylinder gap of 0.2 mm with a piston jump stroke of up to 30 mm. Has anybody experiences in succeeding in this kind of example with Star-CD, especially by adding/removing cells during mesh motion? Thanks & regards

December 23, 2002, 04:22	Re: Adding cells during mesh motion	#2
Jane Guest Posts: n/a	I had simulated a flow in a cylinder gap of 0mm with a piston jump stroke of up to 2mm,but without using adding/removing cells during mesh motion.What difficults did you face in doing it?Perhapes I can help you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh motion Hex cells vs tets	kev4573	OpenFOAM Running, Solving & CFD	6	December 13, 2007 15:37
Oscillatory mesh motion setup mesh flux ERROR	jaswi	OpenFOAM Running, Solving & CFD	5	August 23, 2007 05:41
Adding self written mesh to runtimeselection	bfa	OpenFOAM	2	June 26, 2007 10:02
adding a node in 2D mesh (gambit)	Ralf Schmidt	FLUENT	0	August 24, 2006 02:32
adding a note in 2D mesh (gambit)	Ralf Schmidt	Main CFD Forum	1	August 23, 2006 08:19