 |
 |
 |
|
|
|
[Sponsors] | ||||
September 23, 2002, 07:28
|
icem and star-cd
|
#1 |
|
Guest
Posts: n/a
|
I am using Star-cd3.10B,i think that the post ptocess in it is not good for me ,i want to output the star-cd's result to Icem cfd,then process it with Icemis, is it possible? how to output the result as Icem format?
|
|
|
||
|
September 23, 2002, 09:07
|
Re: icem and star-cd
|
#2 |
|
Guest
Posts: n/a
|
Icem output was not available in 3.1b. You have to upgrade to the latest version.
|
|
|
|
||
|
September 23, 2002, 10:34
|
Re: icem and star-cd
|
#3 |
|
Guest
Posts: n/a
|
thank you very much!!linux 3.15 ok?
|
|
|
|
||
|
September 23, 2002, 11:06
|
Re: icem and star-cd
|
#4 |
|
Guest
Posts: n/a
|
thank you very much!!but I enter "icem"in the output ,the the following is PRO *> icem
ENTER ROOT OR WRITE what is the meaning? |
|
|
|
||
|
September 24, 2002, 09:28
|
Re: icem and star-cd
|
#5 |
|
Guest
Posts: n/a
|
It is a "placeholder" for the eventual ICEM conversion command. It has no real code behind it until later versions of prostar.
|
|
|
|
||
|
September 29, 2002, 13:42
|
Re: icem and star-cd
|
#6 |
|
Guest
Posts: n/a
|
Only ProSTAR v3.103.520 can output to ICEM's Visual3. I guess it's finally out but is available only through special request. Contact your agent/distributor. At this time of writing, the newest version of STAR-CD, v3.150A, comes only with ProSTAR/AM v3.103.519.
Alternative technique: just export in Tecplot format and have Visual3 open it. |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mesh Transfer from ICEM to STAR CCM+ | Waseem Siddique | Siemens | 4 | February 12, 2009 07:02 |
| Exporting mesh from ICEM to Star ccm+ | Ahmed | Siemens | 3 | January 29, 2009 19:15 |
| CATIA TO ICEM/STAR | user001 | CFX | 1 | June 20, 2008 13:49 |
| ICEM to Pro-star | Bhaskar | Siemens | 1 | October 29, 2004 05:05 |
| Problems with ICEM 4.2.2 + STAR-CD | DIA | Siemens | 2 | June 17, 2004 13:42 |
Linear Mode
