 |
 |
 |
|
|
|
[Sponsors] | ||||
July 28, 2002, 05:31
|
create new surface
|
#1 |
|
Guest
Posts: n/a
|
Dear Sir, I am doing meshing for intake manifold using proam I want to generate the new surface for geometry.While diong the create new surface it is destoring the surface at the inlet and outlet side of geometry.I tried differant cell length from 4 to o.05 then also same thing haaping. Can anybody help me to solve this prpblem Thank you Subhash
|
|
|
||
|
July 29, 2002, 09:53
|
Re: create new surface
|
#2 |
|
Guest
Posts: n/a
|
you have to fix the original surface first.
|
|
|
|
||
|
July 30, 2002, 04:53
|
Re: create new surface
|
#3 |
|
Guest
Posts: n/a
|
Dear Subhash,
You can use the custom mesh, with suitably refined in those regions. Also make sure that you have generated Edge Lines and Points before making the surface. Alternaletly generate the surface mesh using PATRAN and import the surface mesh. Regards, AK Balasubramanian |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to create a circular surface? | Jen | FLUENT | 7 | December 7, 2020 14:09 |
| Iso-surface: How do you create and display? | Lukasz Mosakowski | FLUENT | 5 | August 15, 2011 16:08 |
| Help ! Create surface for sliding mesh. | YH Tan | FLUENT | 0 | October 5, 2008 05:21 |
| How to create a hole on the surface | Radhika | Siemens | 4 | December 8, 2006 06:16 |
| Create Thin Surface in Mesh2CAD | Jeniffer | CFX | 0 | November 4, 2003 18:24 |
Linear Mode
