 |
 |
 |
|
|
|
[Sponsors] | ||||
July 1, 2002, 12:33
|
Inlet boundary condition
|
#1 |
|
Guest
Posts: n/a
|
Dear Sir,
I want to give boundary condition for intake valve opening and closing at each crank angle in 4 stroke 4 cylinder I C Engine at constant speed and load.So what procedure should i follow? And how should i consider the valve overlaping phenomenon? Can anybody help me to solve this problem. Thank you subhash |
|
|
||
|
July 2, 2002, 03:39
|
Re: Inlet boundary condition
|
#2 |
|
Guest
Posts: n/a
|
You should take data from charge exchange calculation and read them in via user routine.
regards |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set two inlet boundary condition???Plz help | asghari | FLUENT | 1 | October 17, 2013 14:45 |
| Inlet boundary condition | Andreas | Siemens | 6 | February 25, 2003 01:34 |
| Inlet boundary condition | CFX Begineer | CFX | 6 | October 29, 2002 08:05 |
| inlet boundary condition | abdul aziz jaafar | Main CFD Forum | 1 | August 5, 1999 17:56 |
| [Q]concerning about inlet boundary condition | ghlee | Main CFD Forum | 0 | September 26, 1998 08:03 |
Linear Mode
