|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello,I'm beginner user of Star-CD.
I'm study critical nozzle in a pipeline. *Nozzle shape : axisymmetric converging-diverging nozzle has a converging section consisting of a circular arc that passes through the throat to a point of tangency at which the shape becomes conical. *I had to make a 3D model. *1) How make????? *2) How make cartesian coord. surface -> cylindrical coord. surface ? ex) User guide 3-6, Figure 3-10(a) surface. Please, detail. Thank you. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Don't use Prostar for meshing. It's too time consuming. I would recommend to use ICEM Hexa/Tetra.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thank you.
================================================== =================== (p,T : absolute value.) 1) Boundary condition : *Stagnation(upstream) : velocity=abs, P=2e+05, T=294K, direction=normal *Pressure(exit) : open air(P=9922.8001) *Symmetry *Wall : Np-slip 2)Thermophysical..... *Molecular Properties -density = Ideal-f(T,P) *Turbulence off *Thermal off *Refference data : press=2e+05, temp.=294,Cell NUmber=1(inlet point) ================================================== ================== I think.... the nozzle is converging-diverging. so Ma=1(at throat). but, Ma=1 point --> divergent portion of the nozzle. What is the problem? Please, teach me. Thanks..... |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Create the 2D mesh using Shell type.
then VCEXTRUDE it into 3-D. refine the mesh in the third direction. You will get a 3-D mesh of Fluid type. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help needed for airfoil mesh creation using GAMBIT | Alagesanj | FLUENT | 2 | October 20, 2008 11:39 |
PSD creation | hosseini | CFX | 2 | February 23, 2008 08:25 |
Various types of Mesh creation | Wooster | CFX | 0 | October 18, 2007 15:53 |
Mesh Creation | Nikos | Siemens | 5 | February 1, 2007 20:43 |
[Other] Problem during creation of a new mesh generator | klaus | OpenFOAM Meshing & Mesh Conversion | 8 | July 18, 2005 05:25 |