|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi, all. I found the warnings about temperature by viewing .info file. But I can't understand why they appear in my .info file.
The file is following... ----------------------------------------------- WARNING#1. Temperature less than min. range temp. at 147 cells. Minimum temp. of .100E-24 at cell 4001. WARNING#2. Temperature less than min. range temp. at 148 cells. Minimum temp. of .100E-24 at cell 4001. WARNING#3. Temperature less than min. range temp. at 149 cells. Minimum temp. of .100E-24 at cell 4001. WARNING#4. Temperature less than min. range temp. at 150 cells. Minimum temp. of .100E-24 at cell 4001. : : (they appear after every iteration) ----------------------------------------------- Cell 4001 is one of my inlet boundary cells. Its initial and boundary temp. are 300K. I can't understand the mean of the above and hope someone may tell me why. Thank you. |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Have ypu check the velocity component at that location? It might be the sudden change of velocity. also could u explain ur case more detail?
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
static temperature more than total temperature ?? | mahesh | FLUENT | 4 | May 18, 2016 07:09 |
static temperature and total temperature | showwa | FLUENT | 3 | March 24, 2016 06:58 |
inlet temperature = outlet temperature | Thierry | FLUENT | 4 | March 17, 2006 11:14 |
Radiation temperature and Mean radiant temperature | Arnold | FLUENT | 0 | March 16, 2006 06:35 |
warning #052 | Jane | Siemens | 4 | March 26, 2004 08:28 |