 |
 |
 |
|
|
|
[Sponsors] | ||||
January 3, 2002, 10:58
|
Mesh re-make
|
#1 |
|
Guest
Posts: n/a
|
Is there a possibility to apply an existing model set up (boudaries, scalars, chem. reactions, etc.) on a new (more dense) mesh?
|
|
|
||
|
January 4, 2002, 06:45
|
Re: Mesh re-make
|
#2 |
|
Guest
Posts: n/a
|
Yes: just use CREF command to refine the mesh and boundaries will be automatically refined and other setup will be kept.
|
|
|
|
||
|
January 4, 2002, 08:53
|
Re: Mesh re-make
|
#3 |
|
Guest
Posts: n/a
|
Yes, but then I have problems merging vertices. The problem is that I work with 6-degrees sector and merging just deletes the central cells.
|
|
|
|
||
|
January 4, 2002, 10:04
|
Re: Mesh re-make
|
#4 |
|
Guest
Posts: n/a
|
I think you probably need to adjust the tolerance of the merging so that it is less than the minimum vertex distance.
|
|
|
|
||
|
January 4, 2002, 10:31
|
Re: Mesh re-make
|
#5 |
|
Guest
Posts: n/a
|
The problem is not to adjust it too much. What is the limit value?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to make the hexaedrical mesh with interface? | Rogerio Fernandes Brito | CFX | 0 | December 18, 2008 09:35 |
| how can i make the | lanmayi | FLUENT | 0 | November 12, 2008 02:26 |
| How to make UDS ? | kimhs | FLUENT | 0 | July 15, 2008 04:07 |
| How to make boundary layer mesh moving with wall | wayne | FLUENT | 3 | June 12, 2008 00:23 |
| CFX 5.5 how to make it rotate? | Marco | CFX | 0 | November 11, 2004 10:26 |
Linear Mode
