 |
 |
 |
|
|
|
[Sponsors] | ||||
December 13, 2001, 02:48
|
Help in Loading STARHPC on SGI Origin 2800
|
#1 |
|
Guest
Posts: n/a
|
I need help in loading the parallel (STARHPC) version of starCD on a SGI Origin 200 machine. I need help in setting up the environment using ProHpc.
Thanks Anindya |
|
|
||
|
December 13, 2001, 14:04
|
Re: Help in Loading STARHPC on SGI Origin 2800
|
#2 |
|
Guest
Posts: n/a
|
Get the "mpi" and "array" software from the sgi page, install them and type "/etc/chkconfig arrayd on" . Then either start the array deamon manually or reboot the machine. Nothing more should be required.
There also exists a very nice description about HPC on SGI written by Ayad Jassim, but for some strange reason this document was never provided with the installation. |
|
|
|
||
|
December 13, 2001, 14:22
|
Re: Help in Loading STARHPC on SGI Origin 2800
|
#3 |
|
Guest
Posts: n/a
|
How can I get hold of the documentation by Ayad Jassim?
Anindya |
|
|
|
||
|
December 13, 2001, 18:46
|
Re: Help in Loading STARHPC on SGI Origin 2800
|
#4 |
|
Guest
Posts: n/a
|
You might ask the support people in London. Since you do not post your email I cant send you the file.
|
|
|
|
||
|
December 13, 2001, 19:43
|
Re: Help in Loading STARHPC on SGI Origin 2800
|
#5 |
|
Guest
Posts: n/a
|
||
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stl from SolidWorks getting the origin right | sjs | OpenFOAM Pre-Processing | 2 | July 23, 2008 16:43 |
| where is the origin of a boundary face for udf | ma jie | FLUENT | 1 | August 14, 2006 16:21 |
| submit a job on the SGI Origin 3800 | Jason | FLUENT | 0 | February 28, 2005 23:30 |
| Coordinate of axis origin | Tang | FLUENT | 0 | October 4, 2004 17:38 |
| How to use all the memory in SGI Origin 2000 | G.P. Xia | Main CFD Forum | 3 | April 24, 1999 12:23 |
Linear Mode
