|
[Sponsors] |
December 9, 2001, 14:17 |
Meshing in StarCD
|
#1 |
Guest
Posts: n/a
|
How can I create a boundary layer mesh using prostar ? I am modeling a 2D axisymmetric (I am using cylindrical coordinate system, with just 1 divison in theta direction) jet where I want a finer mesh near the impingement wall and also near the jet exit.
Thanks |
|
December 10, 2001, 03:25 |
Re: Meshing in StarCD
|
#2 |
Guest
Posts: n/a
|
refinement of cells near the wall?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
can not run starcd 3.15 in windows XP? | xhliu1 | Siemens | 2 | November 3, 2006 11:46 |
New to StarCD | Matt | Siemens | 2 | September 23, 2005 22:50 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Convert from StarCD 3.10 to StarCD 3.15 | Jing | Siemens | 1 | April 17, 2002 09:22 |