|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I used to do the simulation with star-cd3.05b. Now I got the new verion of 3.10a. But it can not read the file of 3.05b. So I save the coded file in 3.05b, and then read those coded file, such as vertex file and cell file in 3.10a. But the porblem is that I could not save the model in 3.10a. everytime I saved the file and quit. I could not resume the saved file, it do not display any wrond message, but the contant is empty. Is it the bugs?
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
I dont know if its a bug or not, but 3.10a is about 2 years or more out of date. No one will be interested in debugging it. Why don't you switch to 3.15? It is far more robust all around than 3.10a.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
It sounds like a similar problem that I have experienced in version 3.15. My mistake was that I was using IBM-AIX with a fortran compiler that was too old (compared to the requirements of starcd). Changing to a machine with a newer version of fortran fixed the problem!
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
I have installed 3.05 and 3.10 on the same machine. All can run without fortran problem. Maybe it's not the problem of fortran complier.
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] ParaView exiting while trying to save image file or movie file | 21kalee | ParaView | 3 | January 23, 2008 16:01 |
All residual save file | I.G. Kang | FLUENT | 0 | February 12, 2007 20:31 |
Save file problem | phinix | FLUENT | 0 | February 8, 2007 00:07 |
How save selection in Star-CD? | SanyaKrasnoyarsk | Siemens | 2 | February 1, 2006 04:37 |
star-cd save problem | fevzi topcu | Siemens | 1 | September 7, 2005 11:18 |