|
[Sponsors] |
create executable and batch file in text mode |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi all,
I am on vacation and I would like to start a calculation without using the GUI (too slow for my connection). Instead I use the text mode (prostar and then x). Unfortunately I left the manual at work. So far, I have managed to create the star.mdl, star.geom, and param.prp. However, I have not figured out how to create the executable and later the batch file. If you could help me with this I would be very grateful. Regards, Johan |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
starlink -c "casename"
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
thanks!!
|
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to create input file to run fluent in batch | Aireen | FLUENT | 6 | November 21, 2016 08:27 |
cleaning gambit journal file in batch mode | HK | FLUENT | 0 | April 1, 2008 20:35 |
gcc and executable file from Mac to Linux | simone Marras | Main CFD Forum | 0 | April 8, 2007 15:49 |
create a hardcopy of boundaries in batch mode | Fab | Siemens | 4 | January 8, 2007 04:21 |
How to create a batch file | Liam | CFX | 8 | May 9, 2005 07:43 |