|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: May 2024
Posts: 2
Rep Power: 0 ![]() |
Hi
I am using starccm+ V.23 double precision (64 bit), and i want to export mesh file in CGNS (HDF5) format which contains tetrahedral mesh and prism layers. 1. When I re-import CGNS file in STARCCM+ it works fine. 2.When I try to read CGNS mesh file in TECPLOT it gives error message that its not a 32bit format 3.When I try to import in ANSYS FLUENT, It gives error "no nodes read". What are possible reasons for this error ? Any help is much appreciated. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
SparceImage v1.7.x Issue on MAC OS X | rcarmi | OpenFOAM Installation | 4 | August 14, 2014 06:42 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |