 |
 |
 |
|
|
|
[Sponsors] | ||||
September 6, 2024, 06:09
|
angle of repose
|
#1 |
|
New Member
maple
Join Date: Aug 2023
Posts: 3
Rep Power: 3  |
Hello REEF3D Team and Everyone I have a question for angle of repose.
For example，when i set S 81 35（angle of repose，midphi parameter）and S 82 5（Deltaphi parameter），does it mean that the phi is 30 for the uphill bed slope and the phi is 40 for the downhill bed slope？ The version is REEF3D-24.03 and DIVEMesh-24.03. |
|
|
|
|
|
September 25, 2024, 07:48
|
|
#2 |
|
Super Moderator
Hans Bihs
Join Date: Jun 2009
Location: Trondheim, Norway
Posts: 403
Rep Power: 19 |
Yes, this is correct. The angle varies smootly depending on the flow's alignment with bed slope.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent UDF Mesh Motion Issue: Blade Pitch w/ Respect to Azimuth Angle | recmvp | Fluent UDF and Scheme Programming | 0 | July 30, 2023 16:50 |
| twoPhaseEulerFoam: Defining angle of repose and viscosity for solid phase | RL-S | OpenFOAM Running, Solving & CFD | 9 | September 2, 2022 13:01 |
| Dynamic contact angle issue: fluent UDF couldn't set the correct contact angle | FelixJJ | FLUENT | 2 | October 20, 2021 03:39 |
| [Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 06:50 |
| Normal vector, slope and aspect angle | g_niro | Main CFD Forum | 0 | February 2, 2011 18:24 |
Linear Mode
