Use the F 10 1 command to simulate open-channel flow or flow with pier

Yuhang Zhang · November 12, 2023, 13:24

Dear members of the REEF3D,

I hope this message finds you well. I want to express my sincere gratitude for your program, which has allowed me to successfully simulate two-phase flow with a free surface and scour around different structures. In attempting new cases, I am interested in exploring the possibility of improving computational speed by closing the free surface due to the deep water depth. I want to use one-phase flow (F 10 1) without a free surface for simulation. However, I have encountered challenges, as my attempts to implement this approach have not yielded successful resultserror.jpg.

I am reaching out to seek assistance and guidance from the community. I appreciate any insights, knowledge, or experiences you may share regarding this matter. Thank you for your time and support.

Best regards,
Yuhang Zhang

valgrinda · November 30, 2023, 06:54

F 10 1 is a bit of an experimental option and does not really work. If you are interested in a faster simulation for open channel flow, you could check out SFLOW.

Yuhang Zhang · November 30, 2023, 21:33

Thank you for your response and advice! I'll give it a try in my simulations.

November 30, 2023, 06:54		#2
valgrinda Super Moderator Hans Bihs Join Date: Jun 2009 Location: Trondheim, Norway Posts: 403 Rep Power: 19	F 10 1 is a bit of an experimental option and does not really work. If you are interested in a faster simulation for open channel flow, you could check out SFLOW. __________________ Hans Bihs Team REEF3D www.reef3d.com

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 04:30
[OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0	tlcoons	OpenFOAM Installation	13	April 20, 2016 18:34
Open Channel Flow	ElanMorin	FLUENT	4	February 25, 2015 17:26
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 10:17
Open channel flow	motaba	Main CFD Forum	4	March 26, 2011 04:22

November 30, 2023, 21:33		#3
Yuhang Zhang New Member Yuhang Zhang Join Date: Mar 2023 Posts: 3 Rep Power: 3	Thank you for your response and advice! I'll give it a try in my simulations.