|
[Sponsors] |
HOW to define ONE LINE the WALL boundary condition using pointwise V16 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 27, 2010, 11:40 |
HOW to define ONE LINE the WALL boundary condition using pointwise V16
|
#1 |
New Member
Xu Zhu
Join Date: Oct 2010
Posts: 12
Rep Power: 15 |
hello everyone:
Today i encounted a new problem: i have generated an unstructured grid around a parafoil, to be simpler, it is just a LINE. However, i found it is impossible to define the line the WALL boundary condition. i have tried many times but failed. i use pointwise V16.02 help! Last edited by lachie; October 27, 2010 at 21:11. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 04:41 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |