|
[Sponsors] |
Controlling spacing in normal extrusion in gridgen |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 17, 2010, 07:01 |
Controlling spacing in normal extrusion in gridgen
|
#1 |
Super Moderator
|
If you use normal extrusion to create a grid in gridgen, you can specify the initial . But this initial value is used all along the geometry. Is it possible to use an initial which will scale with the spacing on the connector itself.
For example near airfoil LE, the spacing along the connector is smaller than that somewhere in the middle of the airfoil. The spacing in normal extrusion must be smaller at LE than near the middle of airfoil. How to achieve this ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gridgen node spacing | Vincent | Pointwise & Gridgen | 4 | August 7, 2016 18:33 |
[CAD formats] my stl surface is seen as just a line | rcastilla | OpenFOAM Meshing & Mesh Conversion | 2 | January 6, 2010 02:30 |
GRIDGEN BLOCK Extrusion | oe | Pointwise & Gridgen | 2 | December 8, 2008 21:21 |
Concave meshing in Gridgen | Joel | Pointwise & Gridgen | 1 | July 28, 2007 16:07 |
NACA0012 geometry/design software needed | Franny | Main CFD Forum | 13 | July 7, 2007 16:57 |