 |
 |
 |
|
|
|
[Sponsors] | ||||
December 28, 2023, 12:05
|
Mesh Quality
|
#1 |
|
New Member
Join Date: Oct 2023
Posts: 2
Rep Power: 0  |
Hi everyone,
I started learning pointwise and I intend to make a mesh of a multi-element airfoil setup in 2D. However, when I import the IGS geometry from SW to Pointwise, and try to generate a mesh, the mesh process does not allow me to start generating a mesh unless all the elements are connected by a connector, which I make using a curved connector that joins the TE of one to the LE of the next. The resulting mesh then formed is highly skewed and I wanted to ask how can one overcome this issue? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| flow over cylinder in openFoam | saeed jamshidi | OpenFOAM Pre-Processing | 3 | August 11, 2023 16:16 |
| [Ansys Meshing - Fluent] Want to know the influence of mesh quality | y__tb | FLUENT | 2 | May 12, 2022 22:36 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
