Pointwise Surface Join Issue. -- CFD Online Discussion Forums

November 9, 2023, 15:04	Pointwise Surface Join Issue.	#1
assasins_suprov New Member Rubayed Razib Join Date: Aug 2019 Posts: 2 Rep Power: 0	Hello good people, I am trying to create a simple surface mesh in the pointwise inside a cube. The sphere has six equal domains of equal area. But only any 5 domains out of six can be joined, and the other domain remains ignored. The domains are structured and while joining unstructured mode are switched on. S till the domains are not joined to create a single domain sphere. The reason is to create a single-face mesh for the OpenFOAM simulation and remove all of the connector lines. What can be done in this situation? Is there any kind of convention I need to follow before joining the domains into a single domain? I have attached the drive link of those file with this post. Drive Link Last edited by assasins_suprov; November 9, 2023 at 15:07. Reason: Drive Link not working

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Addlayer issue, added layer doesn't match the surface	Ctholy	OpenFOAM Meshing & Mesh Conversion	1	July 27, 2023 08:26
[ANSYS Meshing] Surface body issue	D0ubleU	ANSYS Meshing & Geometry	0	April 29, 2016 05:46
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 03:09
[snappyHexMesh] Problem with Sanpper, surface still Rough	Zephiro88	OpenFOAM Meshing & Mesh Conversion	7	November 5, 2014 13:05
Build Topology in Pointwise & Local Surface Refinement	nnprashant	Pointwise & Gridgen	1	August 25, 2014 10:26

All times are GMT -4. The time now is 10:59.