[pdp.aero]

Hi there,

Here is something I encountered today.

I do have two connectors, one on the top of another. Their lengths are different so when I distribute nodes with exact begin spacing their spacings don't match exactly on the x direction, which is important for me.

Then I select the lower connector and change the spline parameter to X instead of arch length. Everything is fine if I click on Apply and OK.

However, after changing the spline parameter in the distribution panel if I pick growth and try to re-distribute, PW crashes and stops working and I get the message that PW is not responding!

I am using PW18.3 R2 yet!

So help me understand if I did something meaningless.

Here is the crash message:

Best,
Pay