Home > Forums > Mesh Generation & Pre-Processing Software > Pointwise & Gridgen

Beginner help: Rectangle VG meshing by pointwise

Updated Threads

Reply

Search this Thread

January 18, 2016, 11:52	Beginner help: Rectangle VG meshing by pointwise	#1
mukut Senior Member Mominul MuKuT Join Date: Mar 2009 Location: Bangladesh Posts: 124 Rep Power: 17	Hello all, I would like to simulate the effect of VG on separation. In preliminary case flow domain without VG, the simulated result is quite good in comparison with experimental result. Meshing was done by pointwise. But in next step, when I introduced VGs in flow domain unstructured mesh was generated as attached image. Due to this unstructured meshes, meshes adjacent to VGs were not good. How to make structured mesh for this flow domain? Thanks in advance

Reply

Tags

cfd, mesh, pointwise, vortex generators

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 11:49
[Commercial meshers] CHT case meshing with Pointwise	akrasemann	OpenFOAM Meshing & Mesh Conversion	0	June 17, 2014 06:31
[Commercial meshers] Native OpenFOAM interface in Pointwise	cnsidero	OpenFOAM Meshing & Mesh Conversion	41	May 20, 2012 19:30
[Other] Using Pointwise for FLUENT meshing	m2205	ANSYS Meshing & Geometry	3	September 27, 2011 11:26
Native OpenFOAM interface in Pointwise	Chris Sideroff	Main CFD Forum	0	January 16, 2009 13:37

All times are GMT -4. The time now is 15:12.