[xq712000]

Sometimes, when I project A connector on a database quilt
Then I want to create another connector whose starting point is on the projected connector
HOWEVER, here the problem shows up that:
I CANNOT PICK the starting point on the RIGHT position, instead another position on the quilt far away from the right position.

WHAT ON EARTH IS THE PROBLEM.....I'm totally confused.........OTZ

How to solve this problem ?......................T_T

BTW only pointwise possess this problem

[taxalian]

Hi XieQing,

well in my opinion, make sure that if you have more than one quilt and you want to project the desired connector to a specific quilt then make that only enable that quilt using linear projection.
Otherwise choose the closest near point projection option, it should work normally.
May be it would be better if you can share some images of your problem.

[xq712000]

Originally Posted by taxalian

Hi XieQing,

well in my opinion, make sure that if you have more than one quilt and you want to project the desired connector to a specific quilt then make that only enable that quilt using linear projection.
Otherwise choose the closest near point projection option, it should work normally.
May be it would be better if you can share some images of your problem.

It seems that using "target database selection" will solve this problem !
I often forget to use that function......OTZ

Thanks a lot !