|
[Sponsors] |
March 12, 2006, 05:13 |
How to craete a cylinder with slot jet.
|
#1 |
Guest
Posts: n/a
|
Dear all,
I want to create a cylinder of 9.5mm diameter, 30 cm length including a central longitudunal slot jet of length 6cm and width 0.85mm. Thank you |
|
August 31, 2006, 23:30 |
Re: How to craete a cylinder with slot jet. *NM*
|
#2 |
Guest
Posts: n/a
|
|
|
July 19, 2007, 15:58 |
Re: How to craete a cylinder with slot jet.
|
#3 |
Guest
Posts: n/a
|
Dear
Thank you for every think, I am "Mohammed Alzuhairy" Iraqi engineer and Ph. D student in Chemical Eng. Depart.,and lecturer in Chemical Eng. Depart., University of Technology(Baghdad-Iraq), I read your Message in site(http://www.cfd-online.com/Forum/phoenics.cgi). Dear My research focuses on the implementation and validation of computational fluid dynamics (CFD) tools for Heat transfer in bubble column(gas-liquid-without reaction)., therefore I need CFD Software to setup in my computer(laptop) because it will help me so much to complete my PhD research as "heat transfer in bubble column for viscous liquids"," Nonlinear analysis; Dynamic modeling" Dear you know that I am Iraqi engineer and I live in Iraq in Baghdad exactly not in Japan or USA or . . . ?, so I can't write my state and zip code in internet forms and I have no credit card, no deal with it in Iraq, then I ready to pay any sum of money, but how?. If you want to help me please send me(post it) to my address as shown below(my University) cd of CFD (package Cham (record on cd)) and I ready to send you any or all informations about me or my Ph.D research and also I ready to send you all results of my reseach as you like. With my Best Wishes . . . Mohammed Alzuhairy Student of Ph. D Chemical Eng. Depart, University of Technology-Baghdad-Iraq. Asena'a Street(52 street) Email : alzuhairy1973@yahoo.com Skype: alzuhairy73 Mobile:+9647901538991 or :+9647702566055 |
|
December 14, 2007, 16:41 |
Re: How to craete a cylinder with slot jet.
|
#4 |
Guest
Posts: n/a
|
it is simple,just creat the cylender in pro-E or other cad software and save as stl file,and this file has to stored in the folder of phoenics application as name d_privpc and import the saved stl file though object specification dialog box.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slot jet impinging on cylinder | Diz | CFX | 0 | September 24, 2007 22:34 |
Inlet slot for rooms | myting | OpenFOAM Pre-Processing | 11 | October 1, 2006 09:02 |
Slot jet in cross flow. | Hamdy | FLUENT | 0 | March 5, 2006 05:04 |
impinging slot-jet | ramesh.... | FLUENT | 1 | April 6, 2005 11:35 |
How to do turbulent bc on the injection slot? | peter.zhao | Main CFD Forum | 3 | June 26, 2004 08:05 |