virtual memory?

February 2, 2005, 06:33

Hello, I'm trying to run 3.6 but i'm getting an "insufficient virtual memory" complaint each time. I've set the F-Array to that specified in the prompt as well as doing this /3GB boot.ini switch, but the same complaint appears at every attempt to run. Can anyone help? Thanks

February 3, 2005, 12:40

I think that with 3.6 you increase a variable in the file cham.ini. I would try copying this file (from phoenics\d_appro)to my working directory and increasing the Earth setting.

[F-array] Satellite = 2000000 Earth = 10000000 <-- Increase this one !! Photon = 100000 Pinto = 100000

February 2, 2005, 06:33	virtual memory?	#1
tj Guest Posts: n/a	Hello, I'm trying to run 3.6 but i'm getting an "insufficient virtual memory" complaint each time. I've set the F-Array to that specified in the prompt as well as doing this /3GB boot.ini switch, but the same complaint appears at every attempt to run. Can anyone help? Thanks

February 3, 2005, 12:40	Re: virtual memory?	#2
Mick Hughes Guest Posts: n/a	I think that with 3.6 you increase a variable in the file cham.ini. I would try copying this file (from phoenics\d_appro)to my working directory and increasing the Earth setting. [F-array] Satellite = 2000000 Earth = 10000000 <-- Increase this one !! Photon = 100000 Pinto = 100000

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Virtual memory problem with parallel runs	Ali (Ali)	OpenFOAM Running, Solving & CFD	21	May 25, 2011 05:27
Insufficient virtual memory	sammi	Phoenics	4	April 8, 2009 14:32
High performance virtual memory tip	connclark	OpenFOAM Running, Solving & CFD	0	December 5, 2007 19:35
Help with virtual memory	tom	Phoenics	10	July 19, 2007 15:50
Virtual Mass	Podila	CFX	0	October 4, 2005 13:30