Problems in STL generation

April 26, 2004, 18:17

When I am creating the STL file using AutoCAD 2000 I receive the folowing mensage: "The solid does not lie in the positive XYZ octant". What does it mean?

April 27, 2004, 14:47

DON'T WORRY IS SIMPLE. WHEN YOU ARE CREATING THE STL IN AUTOCAD 2000, YOU MUST BE SURE THAT ALL COORDINATES OF THE SOLID ARE POSITIVE!SO MOVE YOUR SOLID BY THE RIGHT WAY TO LIE IN POSITIVE PLANE (X,Y,Z>0) I HOPE I HELPED YOU, OTHERWISE SEND YOUR STL TO

stkarabelas@hotmail.com and i'll fix it!

August 4, 2004, 09:37

how to set it corectly?

April 26, 2004, 18:17	Problems in STL generation	#1
Sileno Guest Posts: n/a	When I am creating the STL file using AutoCAD 2000 I receive the folowing mensage: "The solid does not lie in the positive XYZ octant". What does it mean?

April 27, 2004, 14:47	Re: Problems in STL generation	#2
STK Guest Posts: n/a	DON'T WORRY IS SIMPLE. WHEN YOU ARE CREATING THE STL IN AUTOCAD 2000, YOU MUST BE SURE THAT ALL COORDINATES OF THE SOLID ARE POSITIVE!SO MOVE YOUR SOLID BY THE RIGHT WAY TO LIE IN POSITIVE PLANE (X,Y,Z>0) I HOPE I HELPED YOU, OTHERWISE SEND YOUR STL TO stkarabelas@hotmail.com and i'll fix it!

August 4, 2004, 09:37	Re: Problems in STL generation	#3
Robert Guest Posts: n/a	how to set it corectly?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems with Fluent on simple 1D problems	agg	FLUENT	3	November 21, 2008 12:55
Problems in grid generation in ICEM	Tim	CFX	1	September 30, 2006 07:43
Droplet Generation	Isahi Patil	Main CFD Forum	0	August 4, 2006 06:11
Model and Mesh generation Problems	Anindya	Main CFD Forum	1	May 19, 2001 03:02
grid generation	G.Balakrishnan	FLUENT	1	November 13, 2000 11:26