some questions about FLAIR

J.S.DU

Hello every: I have studied PHOENICS 3.3 for some months,and now I use FLAIR to do some simulation about building environment.But I have some questions,I hope you would help me. 1:I defined a case in Flair menu,and runed it sucessfully.But I want to change some boundary condition again. when I rerun satellate,the phoenics VR is closed suddenly.So I want to know how can I change some boundary condition again in FLAIR MENU? Is there another method to change them? 2:I defined a inlet in domain,and the inlet air speed is +5 m/s,(along the x axid) but when I back in VR-EDITOR,I found that the inlet attributes/object side is low,infact it should be high, why is it so? Did I make some error? 3:I defined a blockage in domain,but I can't define the heat flux on each side of this blockage.For example ,I want to define the low side of it is 40W/m2,and high side of it is 255w/m2,I don't know how to define it,could you tell me about it? Best wish J.S.Du Be Regards