[General] Paraview: open fluent 13-files

podracer · March 23, 2011, 08:38

Dear all,

I'm struggling with opening the fluent files in paraview. The error message that I get is that unable to open dat-file when I open the case-file. This is the following naming (I had to uncompress from .gz):

case3-11.cas
case3-10-00500.dat
case3-11-01000.dat
case3-12-01500.dat
case3-12-03000.dat

How can I open with the simulated data? Right now I can only see the grid.

aerospaceman · November 23, 2011, 08:55

Hi,

I'm also trying to do the same thing, with similar problems.

Have you solved the problem?

Thanks!

March 23, 2011, 08:38	Paraview: open fluent 13-files	#1
podracer New Member Tobias Join Date: Feb 2011 Posts: 2 Rep Power: 0	Dear all, I'm struggling with opening the fluent files in paraview. The error message that I get is that unable to open dat-file when I open the case-file. This is the following naming (I had to uncompress from .gz): case3-11.cas case3-10-00500.dat case3-11-01000.dat case3-12-01500.dat case3-12-03000.dat How can I open with the simulated data? Right now I can only see the grid.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
polynomial BC	srv537	OpenFOAM Pre-Processing	4	December 3, 2016 10:07
[OpenFOAM.org] Error creating ParaView-4.1.0 OpenFOAM 2.3.0	tlcoons	OpenFOAM Installation	13	April 20, 2016 18:34
[General] Reading Fluent gzip-compressed files to ParaView	larsschwarzer	ParaView	4	August 8, 2014 05:12
[swak4Foam] Error bulding swak4Foam	sfigato	OpenFOAM Community Contributions	18	August 22, 2013 13:41
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 18:18

November 23, 2011, 08:55		#2
aerospaceman Member Join Date: Nov 2009 Posts: 43 Rep Power: 17	Hi, I'm also trying to do the same thing, with similar problems. Have you solved the problem? Thanks!