[OpenFOAM] Paraview graphics window whited out

ozzythewise · February 24, 2011, 10:29

Hello all,

I can use paraview fine but when I go to save state, and then re-open that state file, the graphics window is whited out and I cannot view anything. When I try and rotate the camera I can see graphics, but when I let go of the mouse it becomes whited out again. Any thoughts on this?

Thanks
Jeff

wyldckat · February 24, 2011, 18:53

Greetings Jeff,

The issue you are getting is very similar to the one described here: http://www.cfd-online.com/Forums/ope...-rotating.html

The other possibility is that the version of ParaView you are using has a bug that only happens in certain scenarios. Check the solutions in the thread above and if those don't work, try using another version of ParaView.

Best regards,
Bruno

ozzythewise · March 14, 2011, 14:15

For all interested: The solution was that my graphics settings were messed up on my computer. If anyone has this issue try lowering your graphics resolution, that's what worked for me.

J

February 24, 2011, 10:29	Paraview graphics window whited out	#1
ozzythewise Senior Member jeff osborne Join Date: Mar 2010 Posts: 108 Rep Power: 16	Hello all, I can use paraview fine but when I go to save state, and then re-open that state file, the graphics window is whited out and I cannot view anything. When I try and rotate the camera I can see graphics, but when I let go of the mouse it becomes whited out again. Any thoughts on this? Thanks Jeff

February 24, 2011, 18:53		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,981 Blog Entries: 45 Rep Power: 128	Greetings Jeff, The issue you are getting is very similar to the one described here: http://www.cfd-online.com/Forums/ope...-rotating.html The other possibility is that the version of ParaView you are using has a bug that only happens in certain scenarios. Check the solutions in the thread above and if those don't work, try using another version of ParaView. Best regards, Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Graphics card for Paraview	flotus1	Hardware	15	January 27, 2019 14:22
[OpenFOAM.org] ParaView: Open File window gets bigger and bigger until it's impossible to press open	mn16mg	OpenFOAM Installation	3	January 10, 2019 12:17
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 22:41
How to change and fix the size of graphics window?	Rob	FLUENT	1	February 7, 2003 11:15
Problem: graphics display in prostar main window	Jiaying Xu	Siemens	8	February 14, 2002 09:08

March 14, 2011, 14:15		#3
ozzythewise Senior Member jeff osborne Join Date: Mar 2010 Posts: 108 Rep Power: 16	For all interested: The solution was that my graphics settings were messed up on my computer. If anyone has this issue try lowering your graphics resolution, that's what worked for me. J