|
[Sponsors] |
[OpenFOAM] Mesh always visible when using slice, how can I remove this |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 17, 2011, 03:54 |
Mesh always visible when using slice, how can I remove this
|
#1 |
New Member
ceder
Join Date: Jan 2011
Posts: 1
Rep Power: 0 |
Hi,
My problem is that the mesh is always visible when using slice on an ensight .case file which has been exported from ANSYS Fluent. When choosing Surface with edge it is more pronounced but it is always visible even when choosing Surface. However, using clip the plot is smooth and without mesh. The same thing occurs when using contours. The mesh is visibloe on the iso-surface. Any idea, why this is? I'm using 3.8.1 on windows, mac and linux. Same problem everywhere. |
|
Tags |
paraview fluent mesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |
[ICEM] Terrible Mesh in the middle slice | Eleven Leo | ANSYS Meshing & Geometry | 2 | January 4, 2019 18:48 |
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 05:03 |