|
[Sponsors] |
[OpenFOAM] paraFoam, problem loading 'volume fields' |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Super Moderator
Philip Cardiff
Join Date: Mar 2009
Location: Dublin, Ireland
Posts: 1,091
Rep Power: 34 ![]() ![]() |
Hi,
When I open paraFoam, the only 'Volume Fields' I have a choice to load are those that are in the '0' time directory. For example, when I run the 'hole in plate' tutorial, the only 'volume fields' I can load are 'U' and 'T', even though the other time directories have sigma etc in them. Does anyone know why this is the case? I just installed OF-1.5 and recompiled paraView and OF. I am using OpenSUSE 11.0. I realised that if I copy the results from one of the other time directories into the '0' time directories then I have a choice to load them in paraFoam, and paraFoam will load all the other time directories correctly. Any ideas are welcome, Philip C |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] blockMesh error - Negative Volume Block | adoledin | OpenFOAM Meshing & Mesh Conversion | 2 | June 22, 2016 10:44 |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
multiphase turbulance case floating error | harsha_kulkarni | OpenFOAM Running, Solving & CFD | 3 | February 18, 2016 05:06 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |