[OpenFOAM] Question about the kivaTest tutorial

johan · October 16, 2008, 10:44

Hi everybody!

I am trying to simulate an ignition using the kivaTest tutorial. I want to simulate the flame front and how it propagates inside the cylinder.

I have run kivaToFoam and then the computations from crank angle -40 to 40 with just some small
modifications of the tutorial case.

But when I load the case in paraView3.3.1 I cannot see the flame itself, only how the colour of the walls and bottom of the cylinder mesh is changed (for example for Xi or b).

Is there anyone who knows how to 'see' the flame itself? (As if I have forgotten the interior part of the cylinder) Maybe there are some alternatives I need to mark in the 'display' menu for the case in paraView3.3.1?

Any hints are very welcome!

Thanks,

Johan

johan · October 27, 2008, 08:07

Hi again!

If anyone can give me any hints I would appreciate it very much.

Thanks,

Johan

October 16, 2008, 10:44	Question about the kivaTest tutorial	#1
johan New Member Johan Svensson Join Date: Mar 2009 Posts: 10 Rep Power: 17	Hi everybody! I am trying to simulate an ignition using the kivaTest tutorial. I want to simulate the flame front and how it propagates inside the cylinder. I have run kivaToFoam and then the computations from crank angle -40 to 40 with just some small modifications of the tutorial case. But when I load the case in paraView3.3.1 I cannot see the flame itself, only how the colour of the walls and bottom of the cylinder mesh is changed (for example for Xi or b). Is there anyone who knows how to 'see' the flame itself? (As if I have forgotten the interior part of the cylinder) Maybe there are some alternatives I need to mark in the 'display' menu for the case in paraView3.3.1? Any hints are very welcome! Thanks, Johan

October 27, 2008, 08:07	Hi again! If anyone can giv	#2
johan New Member Johan Svensson Join Date: Mar 2009 Posts: 10 Rep Power: 17	Hi again! If anyone can give me any hints I would appreciate it very much. Thanks, Johan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Please help: Question regarding inletOutlet/outletInlet boundary conditions	sahmed	OpenFOAM Running, Solving & CFD	4	March 2, 2017 18:27
Guide: How to ask a question on the forums	jola	Site Help, Feedback & Discussions	0	July 29, 2016 19:52
Trying to understand how engineFoam and kivatest tutorial work	MikeHersee	OpenFOAM Running, Solving & CFD	1	August 21, 2015 17:15
How to start the engineFoam kivaTest tutorial?	massive_turbulence	OpenFOAM Pre-Processing	12	August 8, 2015 06:46
[Virtualization] OpenFOAM oriented tutorial on using VMware Player - support thread	wyldckat	OpenFOAM Installation	2	July 11, 2012 17:01