[PierreLCV]

Dear All,
I am posting my message here after tried without success on the dedicated paraview website. I am currently trying to learn more precisely OpenFOAM12 after achieved very basic tutorial where everything was working very well. To go further, I am trying to do a conjugate heat transfer simulation (the coolingSphere case in th tutorial list of exemple). I have performed the calculation and as it performed in a parallel process, I have reconstructed my data and now I think I have everything read to be opened in Paraview (basically, i have run the Allrun file...). Unfortunately, when I open Paraview loading coolingSphere.OpenFOAM, I do not have the possibility to plot the fluid quantities (velocity, pressure, temperature…). I just have access “Solid Color”, “vtkBlockColors”… So basically, no possibility to open data in Paraview.
I have checked the case folder and I have all the folders for each step time resolved and inside there are files containing velocity, pressure… data for the different domains (solid, fluid). Consequently, I am a bit stuck here as normally once the calculations were done I just had to open paraview from my case folder and the data were immediately ready to be plotted…
Sorry if my question is a bit silly, i am a very beginner with OpenFOAM and Paraview…
THANK YOU !
Pierre