 |
 |
 |
|
|
|
[Sponsors] | ||||
[General] show the name of surface (Patch Name tick not shown) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 2, 2021, 05:52
|
show the name of surface (Patch Name tick not shown)
|
#1 |
|
Senior Member
mohammad
Join Date: Dec 2010
Location: UK
Posts: 246
Rep Power: 16  |
Hi everyone,
I am just new in OpenFoam and Paraview. Does anyone know how to show the name of surfaces in Paraview 5.4.1? (There is a "Patch name" in the pipeline which could be used to show the name of the surfaces. However, when I go to my Paraview 5.4.1; I cannot find this tick option. Thanks |
|
|
|
|
|
February 16, 2023, 08:54
|
|
#2 |
|
Member
Join Date: Apr 2018
Location: UK
Posts: 78
Rep Power: 8 |
The Show Patch Names tick box will appear for dummy files ending in ".OpenFOAM" extension but appears to not be available for dummy files ending in ".foam".
$ paraFoam -touch will create the file ending in .OpenFOAM $ paraFoam & as normal should now display the Show Patch Names tick box. Make sure you select your patches under Mesh Parts (besides the internal mesh). See also: http://www.tfd.chalmers.se/~hani/kur...amTutorial.pdf |
|
|
|
|
|
|
| Tags |
| patch name, surface name; ver 5.4.1 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with cyclic boundaries in Openfoam 1.5 | fs82 | OpenFOAM | 37 | November 29, 2024 11:15 |
| SU2 7.0.7 Built on CentOS 7, parallel computation pyscript mpi exit error? | EternalSeekerX | SU2 | 3 | October 9, 2020 19:28 |
| [snappyHexMesh] Bad meshing result on corrugated metal sheet | UebertreibeR | OpenFOAM Meshing & Mesh Conversion | 1 | August 19, 2016 05:55 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 04:23 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 05:38 |
Linear Mode
