|
[Sponsors] |
February 23, 2021, 08:48 |
Different values of massflow
|
#1 |
New Member
Hiren Tala
Join Date: Oct 2016
Posts: 22
Rep Power: 9 |
Hi everyone.
I am simulating very small portion of pipe with 90° angle with curvature at the corner. the massflow at the cross section with slice, if i calculate, it comes different at inlet and outlet. there is no source or no other inlet inbetween. What could be the problem? I am using Simflow GUI and Paraview for Postprocessing. Thanks! Best Regards Hiren |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cell values vs node values | reversemermaid | FLUENT | 0 | March 13, 2014 18:06 |
Problem with plotting the Massflow in 2D-Axisymmetric | Bando | STAR-CCM+ | 1 | June 21, 2012 05:09 |
MassFlow Function? Absolute MassFlow? Failure in Caclulation | eRzBeNgEl | CFX | 0 | May 5, 2011 09:46 |
strange node values @ solid/fluid interface - help | JB | FLUENT | 2 | November 1, 2008 12:04 |
re: Massflow reset in CFX 10 | Wooster | CFX | 5 | March 16, 2007 20:08 |